If you desire to do the job right, get a borescope so you can look down the barrel and really see what's going on. Without a borescope, you're working blind.
It is two separate tasks. Initially, you get to deal with powder fouling. Second, you need to remove copper fouling. Only then are you done. There are all sorts of quality gun-cleaning items out there. Here is a list of what I use. J Dewey nylon-coated cleaning rods. They come in.
Take your spot rod, and put 3 solvent patches up the bore. When it does, follow with a dry patch.
Some Known Facts About How Often Should You Clean A Gun In Storage? - Best Practices.
(Do not get J-B or oil or anything else on the lens of your scope. If you see no copper, or just a faint wash of copper here and there, you're done.
If you don't have a borescope, run a solvent patch up the bore and let it sit, muzzle slightly down, for a number of hours. Run another solvent spot through, and if it comes out tidy, you're done, but if it has green or blue spots, back to the J-B.
As a rule, the more you spend on a barrel the smoother it will be and the less it will nasty. Every barrel fouls to one degree or another. I've had one or 2 cases where a barrel suddenly began to group as I reached the end of the process, however I have actually had far more break-ins that made no difference at all.
How To Clean Your Rifle Chamber - Mdt Ca Can Be Fun For Everyone
They work, in some cases, but if you forget and leave the things in your bore for more than 15 minutes, they will pit your bore however great, and since I'm at the age where I forget things, I hesitate to take the chance. They're hell on stock surfaces. With a bolt-action, go easy on the Break-Free.
Take a cue from the military, whose lives depend on their guns going bang. They desire them spotless. And immaculate is a great method to go.
The steps to correctly clean your rifle depend on whether you are doing a field stripping or total disassembly. Due to the variety of rifles, total disassembly of the gun aren't within the scope of this short article.
The Only Guide to Rifle Cleaning Tips - Remington
, and eliminate any loose particles that may be found within the action, bolt, receiver, frame and chamber.
One typical myth is that more is much better when it comes to lubrication of your firearm.
The treatment is simple. Soak a couple spots in this solvent and run them down the barrel. (Keep in mind, keep your barrel clamped or pointed down to avoid any solvent gathering near the actionsee Action 1.) Allow it to sit, and remember that removing copper can take a while.
How To Clean A Rifle - Gundata.org Fundamentals Explained
If the patch comes out stained blue, you still have copper in the barrel. Simply let it sit again, and repeat. If the spot comes out stained blue, you still have copper in the barrel. Just let it sit once again and repeat. Bill Buckley Keep In Mind: There's a great deal of discuss how these copper solvents can harm your bore.
What you do not desire is to let any ammonia solvent dry out therein. When you're pleased that the copper is gone, run a couple of dry patches down the bore, followed by a couple of spots that have actually been wet with a regular cleansing solvent. Run three or four dry spots down the bore to get rid of any remaining solvent.